Controllers that come with the chiller can be finicky and prone to nuisance trip outs. Each time it trips out spuriously it costs you the price of a call out to reset it. Parts and service are expensive. Over time we can remove the spurious trips through service adjustments and repairs. Better still- fit a new controller...
Controller Swap Out
Chiller rebuild by fitting a new controller is easy and cheap. All of your design requirements can be easily programmed into the new controller. We fit state of the art controls. The old controller is disconnected and removed
For HFC, the transducers and sensors are replaced
For ammonia, the sensors can be re-used as the the program can be set to look at the various types
The new controller is fitted and wired in. Now the chiller is rebuilt- it is run tested and goes into seamless operation. An effective chiller repair with no more spurious trip outs
If a compressor is not available- a chiller refurbishment by selecting a different compressor is required. Chiller compressor refurbishments are relatively easy. The capacity in kilowatts is worked out and a compressor of the same capacity is selected. The machine is pumped down and ancillaries removed. A lift and shift is arranged and the compressor is lifted out. The mounting is adapted for the new compressor and the new one lifted in. Pipework is also adapted. After leak testing the new machine is given a service. It then goes into seamless operation
Why choose Us?
Is your chiller getting old? Have you been told that parts are obsolete? Don't worry- Maximus Chillers can help. We easily fit the updated part to the old chiller- rebuilds are what we are good at! We can extend the life of your plant by as much as 10 years
What We Offer
The complete refurbishment of the chiller. Complete with corrosion and weatherproof paint. National and overseas coverage. Our engineers are the best in the industry
On a site we look after in the South West, our engineer was changing the controller on a chiller. This was his first chiller refurbishment so it takes a lot of guts! His first task was to rip the wires out of the panel! Not the 3 phase or the common neutral- but everything else. Now the chiller will never work again unless the controller is fitted correctly. After the wiring, the pins on the back of the controller need to be programmed for the machine. Needless to say it worked. The customer says better than before- well it should do- it is a Maximus Chiller now!
Schedule a site visit today!